Call now to get tree assistance like tree clearance, tree leaning, bush delimbing, shrub remover, stump cleanup and a lot more around USA.


Call now

Call us +1 (855) 280-15-30






To start the ball joint must be released which can be done using a large.

How to change replace rear lower control arm bushings, trailing arm bushings Caprice. Chevelle nova malibu ford Mustang corvair mazda dodge truck ram s Oct 11, I've already got an g (rear shock bushing) and (front shock bushing) Was considering the upper control arms soon - nice to know the 3rd one i'm looking for is in that set as well (i'd like to keep that stock but you stump removal 19006, 1945 Marblehead MA buy an oem replacement for that specific one on the lca so if its bad than the es will have to do)Estimated Reading Time: 7 mins.

Apr 13, Jun 20, I have been using a ball joint press to remove the bushings. It just seems easier to setup than the press, and the ball joint press has a bunch of adaptors with it. It is the OTC kit, but the down side is it costs more than the Hydraulic press. If getting a press, get the ton is't only 50 more than the ton.

Apr 25, However, it looks like even after I get that piece out, I still will not have room to accomplish the removal of the old bushing sleeve or the installation of the new bushing (already in a sleeve). So, after re-reading RT's post below, it looks like I need to keep on taking things apart until I have completely removed the lower control arm. May 17, Sep 03, After I set up the 6 ton arbor press to install the bushings, I made it all of yards before they popped out of the control arm housing causing metal on metal contact and causing the entire wheel to pivot back.

Nothing about installing the aftermarket bushings instills confidence, in fact it's downright scary.

Oct 23, Nov 17, #1. I've been getting more requests lately for bushing press tools for the Series front upper and lower control arms and the rear upper and lower control arms plus the rear panhard. I already make the kit for the 80 Series: Bushing Press Tool- KIT but now I've committed to make the tools and kit for the s.

Nov 15, Your going to need a press to remove and replace the new bushing, I did all of mine last summer. Your going to need a 18mm thru 21mm wrench's and sockets, remove the brake caliper,rotor, your have to remove the tension strut from the knuckle,strut from the lower control arm,lower control arm from the knuckle. your going to have to use a jack under the. Dec 31, Jan 01, Who makes that on the car upper rear control arm bushing press?

I have some nasty upper bushings that need to be pressed out and new ones in. I think its design has been copied But I only seen them for fords. Perhaps the rear bushing size is differnt I dont know. I know the info used to.